A square isothermal chip is of width w = 5 mm on a side and is mounted in a substrate such that its side and back surfaces are well insulated, while the front surface is exposed to the flow of a coolant at T infinity = I5 degree C. From reliability considerations, the chip temperature must not exceed T = 85 degrees C.
How useful was this post?
Click on a star to rate it!
Average rating 5 / 5. Vote count: 2
No votes so far! Be the first to rate this post.
We are sorry that this post was not useful for you!
Let us improve this post!
Tell us how we can improve this post?
Experimental results for heat transfer over a flat plate with an extremely rough surface were found to be correlated by an expression of the form Nux=0.04 Rex0.9 Pr1/3 where Nux is the local value of the Nusselt number at a position x measured from the leading edge of the plate. Obtain an expression for the ratio of…
The temperature distribution across a wall 0.3 m thick at a certain instant of time is T(x) = a + bx + cx2, where T is in degrees Celsius and x is in meters, a = 200 °C, b = -200 °C /m, and c = 30 °C /m2, The wall has a thermal conductivity…
Consider the geometry of Problem 2.14 for the case where the thermal conductivity varies with temperature as k = ko + aT. where ko = 10W/m-K, a =-10-3 W/m-K2, and T is in kelvins. The gradient at surface B is partial differential T/partial differential x = 30 K/m. What is partial differential T/partial differential y at…
Chips of width L = 15 mm on a side are mounted to a substrate that is installed in an enclosure whose walls and air are maintained at a temperature of Tsur =T=25C. The chips have an emissivity of ε = 0.60 and a max allowable temperature of Ts = 85 C. (a) If heat…
Consider the conditions of problem 1.22. However, now the plate is in a vacuum with a surrounding temperature of 25 C. What is the emissivity of the plate? What is the rate at which radiation is emitted by the surface? All sample problem and notes are based off the following textbook: Fundamentals of Heat and…
Abstract The purpose of this lab was to determine the thermal conductivity k of the disk material by measuring the temperature distribution for transient and steady-state heat conduction in a cylindrical wall. To conduct this experiment cooling water was pumped though the HT10X Heat Transfer service Unit at approximately 1.5 liters/min. Initially the heating power…