Fundamentals of Heat and Mass Transfer – Problem 2.5

An array of 10 silicon chips, each of length L=10 mm on a side, is insulated on one surface and cooled on the opposite surface by atmospheric air in parallel flow with T∞​=24°C and u∞​=40m/s. When in use, the same electrical power is dissipated in each chip, maintaining a uniform heat flux over the entire cooled surface….

You’ve experienced convection cooling if you’ve ever extended your hand out the window of a moving vehicle or into a flowing water stream. With the surface of your hand at a temperature of 30 °C. determine the convection heat flux for a vehicle speed of 35 km/h in air at -5 °C with a convection…

What are Low-E Windows? Low-E windows as defined by http://www.royalprime.com are windows that have two glass panes or more that selectively rejects certain energy which as a result, greatly decreases the amount of heat that transfer through the glass (window glossary, 2012). In this research paper I compare a standard egress double pane  double hung…

Consider the geometry of Problem 2.14 for the case where the thermal conductivity varies with temperature as k = ko + aT. where ko = 10W/m-K, a =-10-3 W/m-K2, and T is in kelvins. The gradient at surface B is partial differential T/partial differential x = 30 K/m. What is partial differential T/partial differential y at…

Consider the conditions of problem 1.22. However, now the plate is in a vacuum with a surrounding temperature of 25 C. What is the emissivity of the plate? What is the rate at which radiation is emitted by the surface? All sample problem and notes are based off the following textbook: Fundamentals of Heat and…