Abstract The purpose of this lab was to determine the thermal conductivity k of the disk material by measuring the temperature distribution for transient and steady-state heat conduction in a cylindrical wall. To conduct this experiment cooling water was pumped though the HT10X Heat Transfer service Unit at approximately 1.5 liters/min. Initially the heating power…
Background and Theory This experiment attempts to determine how volumetric flow rate effects changes in head, shaft power and the efficiency of the pump. To simplify this experiment, some assumption/idealizations were made. During this experiment the system is treated as slow speed, steady state with incompressible flow, the pipe and machine walls are solid so…
Background and Theory This experiment looks at how different obstructions affect the force exerted by a water jet. To obstruct the flow of fluid vanes were used. A vane as defined by Webster’s dictionary is “a thin flat or curved object that is rotated about an axis by a flow of fluid or that rotates…
Background and Theory This laboratory aims to recreate the Moody diagram. Moody plotted the Moody Diagram in 1944, and it is now most famous and useful tool in fluid mechanics. The accuracy of the Moody chart is +/- 15 percent [1]. “The Moody Chart gives a good visual summary of laminar and turbulent pipe friction…
Background and Theory This laboratory experiment investigates the surface tension of different working fluids and how contamination can drastically affect surface tension. Surface tension is a result of the molecules deep within the fluid repelling each other while the molecules at the surface attract each other [1]. Introducing contaminates like detergents into the surface of…
Background and Theory The object is to determine how the density, kinematic viscosity and dynamic viscosity of a sucrose solution, as the concentration of the solution are varied. Density is defined as ratio between the mass over the volume. [1] The expected outcome of this experiment is that there will be a correlation between concentration…
Buckling is a physical occurrence observed in slender structures, such as columns, beams, rods or panel; when it undergoes bending due to applied loads, leading to eventual buckling. This phenomenon can result in the complete failure of the structure. Buckling occurs when the applied load surpasses the structure’s buckling load, which represents the maximum load…
What is the importance of beams? The primary function of beams, regardless of the application, is to act as structural elements that transfer loads. In the civil engineering field, beams refer to horizontal elements which symmetrical sections, such as an i-beam. For example, in a building, beams support the weight of a building’s floors above, ceilings,…
Objective To measure the natural frequency of a vibrating cantilever beam with different lengths using different sampling rates. Known & Assumptions: Materials: The materials required: Thin aluminum beam Piezo-electric sensor Computer with labVIEW Clamp with steel plates Calipers Procedures: To begin measure the overall dimension of the cantilever beam using the calipers (width and thickness)….
Objective To determine the normal stresses in the pressure vessel, and also to observe and material properties of the pressure vessel used. Finally, compare the calculated and measured stresses on the surface of the cylindrical pressure vessel subject to torque while pressurized. Known & Assumptions Materials: The materials required: Technovate Stress Analysis System Model 9800…